625 E North Broadway, Columbus, OH 43214
info@emengineeringgroup.com 614.225.1580

SERVICES

Electrical
Engineering

Power layout of devices including receptacles, low voltage IT receptacles, HVAC equipment, plumbing equipment and associated circuit sizing. Power distribution design including one line diagrams, AIC calculations, load calculations and panel schedules. Lighting design including interior and exterior light fixture specifications, line and low voltage lighting control design, and production of photometric plan sheets to support lighting design. Generator design and specification for required projects including fire pumps, legally required standby systems, and non-legally required standby systems. Uninterruptable Power Supply design and specification for data center projects.

Energy Code Analysis and Documentation

COMCheck is the program most commonly used for the majority of municipalities throughout the United States. This uses either current versions of International Energy Conservation Code OR ASHRAE 90.1 for each associated municipality or state. Florida Energy Gauge through the software EnergyGauge Summit is used for all Florida energy compliance documentation Title 24 documentation is used for mechanical and electrical disciplines for all California energy compliance documentation.

Fire Alarm Protection Design

Notification and input device layout and design based on the customer needs and/or code required coverages within required buildings. Fire alarm control panel design and specification. Fire alarm riser diagram, battery calculations, and voltage drop calculations.

Mechanical Engineering

Computerized heating/cooling load calculation analysis Ventilation design and equipment selection Ductwork distribution diffuser selection Chilled/hot water distribution systems Variable refrigerant flow systems Energy Recovery Natural gas distribution Life cycle cost analysis Title 24 compliance

Computer-Aided Design

Computer Aided drafting, transferring the information from paper or mind to the computer through AutoCAD and/or REVIT programs.

Written Specifications

Book or plan specifications can be included in any project based on the needs of the customer and/or project Book specifications are based on MasterSpec with current CSI formatting